#Enable ssh vmware vsphere client 6.5 install#
#Enable ssh vmware vsphere client 6.5 drivers#

It is not possible to install ESXi on the older DS or X servers.

Please find the cost of an additional compatible NIC here: Root Server Hardware Or you can install an additional compatible NIC.

#Enable ssh vmware vsphere client 6.5 drivers#

To install vSphere 5.5 or newer on the EX40, EX60 and some EX41/EX51 models, you need to use a custom installed ISO that includes drivers for the Realtek NIC ( ).

Therefore, to make sure your system operates smoothly, you should use a server with an Intel NIC (PX60, PX91, DX151 etc.).

The Realtek driver present in ESXi 5.0 to 5.1 Update 2 was just a tech demo that has not been updated.

Please look for current information on your own to make sure they're compatible. However, newer versions are not necessarily compatible.

The models mentioned above should work with the appropriate version.

Starting from 5.5, Update 3 / 6.0, Update 2ДҐ.0 - 5.1 Update 2 since 5.5, additional NIC required Starting from 6.5, Update 2 / 6.7, Update 1 Starting from 6.5a, additional Intel NIC required (All information is subject to change) Model group DX180 and DX181 are compatible from 6.5 onwards.ДЄll other models are not certified by VMware, but in most cases, you can run them with VMware vSphere/ESXi. DX152 and DX292 are compatible from 6.0 onwards. The Dell PowerEdge models DX150, DX151, DX290, DX291 and DX141 are certified and compatible with all versions from 5.0 onwards. Hetzner specific information Installed hardware After selecting this, you can click on the Edit button to the right and then enter the license key. Go to the Configuration tab, the Software section, and then choose Licensed functions in the menu. You can enter the license via the vSphere Client.You can do this by registering on the VMware website: If you want to use the OS for the long term, you need to get a separate (free) license.

Please check out the Installation GuideВ for further information on installing ESXi.ДЄfter installation, the system has a test license which expires after 60 days.

The installation and configuration of ESXi takes about 20-30 minutes, even without any prior knowledge.

To use a subnet, you need to set up an additional single IP as a router VM.

Therefore, you can only use a true bridged setup.

VMware vSphere Hypervisor is an operating system designed for pure virtualization and supports neither NAT nor routing.

The free version of ESXi (starting with 5.5) supports a maximum of 4 TB RAM (formerly 32 GB RAM).

Software RAID is not supported by ESXi.

VMware vSphere Hypervisor 5.x and 6.0 (ESXi) use a filesystem called vmfs5 (formerly vmfs3), which uses GPT and supports drive sizes of up to 64 TiB (formerly 2 TiB).

Created on General information Hardware.